Windmill Scarecrow. Do-it-yourself bird and mole repeller. Pest control скачать в хорошем качестве

Windmill Scarecrow. Do-it-yourself bird and mole repeller. Pest control

How to make a bird and mole repeller from a 6 liter bottle. For this homemade product, I take a 6 liter bottle, cut off the handle and throw it away, since I no longer need it. I heat the nail with a gas burner, and with a hot nail I burn a hole in the bottom of the bottle exactly in the center. I also burn a hole in the lid, make sure that the center is exactly, otherwise it will not work well. I take the wire and check if it goes through the hole I prepared. The wire should preferably be elastic, since the bird is heavy, in my case it is 8 mm in diameter. Next, I draw wings, width 8 cm, a wing long on one side 17 cm, on the other 19 cm. Also on the opposite side of the bottle we draw exactly the same wing, with the same parameters. After the drawing, we begin to carefully cut out the wings. Yes, the walls of the bottle are very soft, it would be nice if they were a little tougher. We bend the wing to the outer side while aligning the bend, as you can see, the wing turned out to be beveled. We do the same ourselves, and with the second wing. Further, I pass part of the straight wire through the bottle into the hole that I prepared earlier. From the side of the cork, I put a washer on the wire, it will serve as a bearing. At the end of the wire, so that it all does not fly away, I wind electrical tape. Also with electrical tape, I will add colors, make a smile, draw teeth and eyes. It turned out some kind of falcon broiler.