Dry-mounting a thin rice paper painting with silicone paper скачать в хорошем качестве

Dry-mounting a thin rice paper painting with silicone paper

Order 10 Yards Silicone paper: https://www.blueheronarts.com/silicon... Chapters 00:00 start 00:01 Cut the silicone paper exactly same as painting 00:14 Mount the silicone paper onto the backing paper 1:16 Peel off the release paper 1:43 Put the painting face up and cover it with release paper 2:07 Set iron on "silk" and iron from center out Mounting Method B: Mount the backing material first This method is to put the silicon adhesive film on the backing material first and remove the release paper, then mount the painting on top of it. Here are the steps: 1. Cut the Silicone Release Paper to the same size as the backing board or a little bit smaller than the board. 2 Place the silicone release paper, film side facing down, on the supporting material(backing paper, museum board, foam board, vellum, watercolor paper, bristol paper, etc) 3. Iron at 180 degrees F or half-way between silk and wool. No water spray is needed. If the table is slippery put 4 layers of denim cloth under the board. 4. Peel the release paper off and save it for use in step 7. 5. If necessary, trim any extra adhesive film along the board edge with a cutting knife or pair of scissors. 6. Lightly spray the front of the painting to relax any wrinkles. 7. Lay the artwork face up on the adhesive film and cover it with the release paper from step 4. 8. Now it's ready to iron on moving from the center out, first in the cross and then in X movements to avoid bubbles. Keep the iron moving and don’t stop in one place.