Portal Axle Upgrade Kit - Everest Gen7 Slipper Clutch Install - RCU скачать в хорошем качестве

Portal Axle Upgrade Kit - Everest Gen7 Slipper Clutch Install - RCU

The Redcat Portal Axle Kit includes a slipper clutch upgrade, with gearing change, intended for the Everest Gen7. Because of the additional gear reduction present in the portal axles, without a gearing change, the Everest Gen7’s top speed will be reduced by about 50%. The slipper clutch system features a lockout system, for those who decide they don’t want the possibility of their drivetrain slipping, but still want the gearing change. In our step-b-step install video of the Gen7 Portal Axle Upgrade Kit Slipper Clutch Upgrade, we'll show you how to swap out the original gear for the new components. For more info visit: http://www.redcatracing.com/RER11289 For the manual for the Portal Axle Kit visit: http://www.dealer.redcatracing.com/ma... Steps by timestamp. Start : 0:05 Parts overview. Slipper clutch purpose and benefits. STEP 1: 1:19 Remove the body. STEP 2: 1:31 Disconnect the motor from the ESC plugs and unplug the steering servo from the receiver CH1. STEP 3: 2:10 Unscrew the side link bolts holding the ESC/receiver tray, center plate, and links together. STEP 4: 2:58 Remove the center plate with motor and transmission. STEP 5: 3:20 Remove the spur gear and the spur gear mounting plate and screws. STEP 6: 4:43 Remove the pinion gear from the motor. STEP 7: 5:24 Remove the drive shaft from the center transmission output shaft on the opposite side of the spur gear. STEP 8: 6:05 Open the transmission case. STEP 9: 7:32 Remove the original top shaft and replace it with the new top shaft. STEP 10: 8:51 Reinstall the back half of the transmission case with original screw and nut and bottom counter sunk screws. STEP 11: 9:49 Mount the motor plate onto the center transmission housing using the three new screws provided and the three original spacers. STEP 12: 11:17 Install the new slipper clutch using the new spacer, metal plates, slipper pads, new spur gear, washers, and lock nut. STEP 13: 13:49 Install the new pinion gear. STEP 14: 15:04 Reset the gear mesh. STEP 15: 16:24 Reinstall the rear portion of the center drive shaft. STEP 16: 17:06 Remount the center plate, ESC tray, and outer links onto the chassis. STEP 17: 19:23 Reconnect the steering servo plug into the receiver CH1 and connect the motor wires to the ESC wires. STEP 18: 20:30 Remount the body. If you run into any issues or need assistance at any point and time feel free to reach out to our support team. Our team is always available and willing to help Mon-Fri 8am-430pm AZ time. http://www.redcatracing.com/Contact Follow Redcat Racing Website: http://www.redcatracing.com/ Youtube:    / redcatra.  . Instagram:   / redcatracing   Facebook:   / redcatracing   Twitter:   / redcatracing   #RedcatRacing #Gen7 #HowTo