У нас вы можете посмотреть бесплатно Waterproofing RC Electronics Using a Hot Glue Gun или скачать в максимальном доступном качестве, видео которое было загружено на ютуб. Для загрузки выберите вариант из формы ниже:
Если кнопки скачивания не
загрузились
НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием видео, пожалуйста напишите в поддержку по адресу внизу
страницы.
Спасибо за использование сервиса ClipSaver.ru
This is another method of waterproofing your RC electronics and does seem to work well. The method of putting the receiver inside a balloon and cable tying it is also good but can fail if the car is under water for a while. One advantage of this method is that you still have access to the plug sockets if you need to change anything. A disadvantage is that the plug sockets are open to mud and sand etc. so you could even use both methods on the same receiver. I usually buy ESC's and servo's that are waterproof from the factory but occasionally end up with some that aren't. Receivers tend not to be for some reason. I don't think that there is a disadvantage to using hot glue on a circuit board. Doesn't seem to have damaged anything so far. Many thanks for watching. Please like and subscribe and all that stuff :-)