Ford 8N Front Mount Distributor Electronic Ignition upgrade скачать в хорошем качестве

Ford 8N Front Mount Distributor Electronic Ignition upgrade

First off: This is not a sponsored video. This was something I needed to do and had to pay for the parts! Sponsors are welcome though! This goes through the process of installing an electronic ignition kit on a Ford 8N with a front mount distributor. I couldn't find any videos on this so figured I'd make one. Fairly simple process, but went over some things that I ran into, and some things to make your life easier if you've never done this before. Sorry for some video/audio issues but this is the first time I've recorded on my laptop, and used 2 cameras. Hope this helps some other folks. Some notes: Make sure you practice safety first. Unhook the battery before performing maintenance on the electrical system! When using a 12V coil, you do not need the additional ceramic resistor, only the 3-post resistor block that is stock on the tractor. You may have to "improvise" a mount for the coil. I used 4 4" hose clamps and strapped the coil to the starter. The wires were just long enough to do this. Parts: Electronic Ignition kit (complete): http://www.yesterdaystractors.com/For... Distributor rear bushing (engine side): http://www.yesterdaystractors.com/For... Discussion boards for older tractors: http://forums.yesterdaystractors.com/ Music: Kentucky Mandolin - Doc Watson and Bill Monroe Logitech C920 Webcam Recorded using OBS Studio