Bench Grinder - Overheating скачать в хорошем качестве

Bench Grinder - Overheating

Mongo was using the old IR bench grinder we restored. SAVED Old IR Bench Grinder -    • SAVED Old IR Bench Grinder - lube bearings...   After a bit of use the body of the grinder was burn the flesh HOT. Couple things can cause overheating. Bad bearings, bad motor windings or a bad capacitor. BE CAREFULL AND SAFE, when working with electricity and capacitors. If you want to figure out why your bench grinder is getting to hot then THIS IS THE BEST VIDEO for you! Test the capacitor - Ohm meter and capacitor meter. Using an Ohm meter touch each terminal of the cap and the reading should fluctuate. Switch to capacitor test and it should read the rated farad rating of the cap. 00:00 HIs STORY 01:00 Testing a BAD capacitor 02:02 Motor winding test Motor test - Ohm meter and measure each end of the different coils. On a 3 wire AC motor (lead A, B, C) measure Lead A to B, B to C and A to C. Measurement of A to C should be the same as adding up A to B and B to C. Would need the spec of the motor to know if the windings measurements are correct 04:29 Split phase AC motor All sorts of different type of AC motors. Be sure you know which type you are working with. This is a PSC AC motor. This type of motor has the capacitor PERMINENTLY attached to each coil. No disengagement of the capacitor circuit. 05:57 Capacitor Identification Should have a label with the manufacture, MFD rating, voltage, PN etc...Make sure to get the same capacitor as the one previously installed. 07:13 Testing a GOOD capacitor 08:47 Testing Grinder Hopefully this video help you if you have a bench grinder with a PSC motor that is overheating. If you like this video, be sure to like this video. If you like this video and other videos from Mongo Fix, please subscribe. MONGO THANK YOU!!! Donations to Mongo Fix - https://gofund.me/b54e05a0