HOW TO MODIFY ULTRAFIRE WF-501B XM-L T6 TACTICAL FLASHLIGHT to 3 Modes Only скачать в хорошем качестве

HOW TO MODIFY ULTRAFIRE WF-501B XM-L T6 TACTICAL FLASHLIGHT to 3 Modes Only

Rebel Without-a-Cause showcases how to modify an ULTRAFIRE WF-501b XM-L T6 led tactical flashlight driver with a AMC7135*8 2800mAh 5-Mode Circuit Board for the following reasons listed below. With this circuit board you can customize your flashlight to one of the following four different modes listed below by soldering the desired mode (star) to the outside ground (-): From Left to Right No. 1 Star: Low, Mid, High, Strobe & SOS (default) No. 2 Star: Low, High, Strobe No. 3 Star: Low, Mid, High No. 4 Star: Low High Image link below for reference: http://img542.imageshack.us/img542/63... It has also been said that replacing the standard driver to a AMC7135*8 2800mAh driver increases the amps drawn from the battery to 3 amps, therefore increasing the lumen output. However, I did not see a difference. The reason I did this modification was because my light output was very low but later discovered that that was due to a bad battery. Getting a new battery corrected/increased the light output. If your newly purchased flashlight and battery have a low light output try a new battery before you do this mod since it is rather difficult. Unless you MUST have a different mode output. -Reference (http://budgetlightforum.com/node/4922) For updates or to play airsoft w/ us please "like" our page on facebook   / airsoft.sbm   -Rebel Without-a-Cause