Laminate floor table 3 скачать в хорошем качестве

Laminate floor table 3

And as at the begining I've glued up my details for legs. They has bevels on the inner side here, and here from outer side. It must to be placed here and attached with the corresponded detail. All connections turned almost perfect. I'll show it… Here inside is a corresponded place for this detail. Very easy to get through. Because I made accurate angles. And need to recall that we have here crossed frame. And such frame has a very strong construction. There are rib stiffeners. And this half of leg, when it will be attached here. It will be not just decorative element. It will carry load. Because glue will make it integral whole. And strength of construction will be very high. I already tried to bend it and have no succeed. Even without these details it doesn't bend. And one more nuance. One more nuance... I've made this bevel with the router, though I have a tablesaw and I can make it with it. I still don't have scale for tablesaw bevel but can measure bevel with pencil marks. I'll try to demonstrate this. What I can say... here after tablesaw I have more rough surface than on the router. It is more porous. But quite flat and accurate. The router makes more smooth surface. But I think that for gluing tablesaw cut would be even better. And router bits quite fast burns on this material. Because It is pressurized dust and other garbage. But I cut not enough to kill router bit. Because It is pressurized dust and other garbage. But I cut not enough to kill router bit. I think saw disc has much more resource to work. And even I cut directly, without previous vertical cut I don't have chips here. So I can do all work with my tablesaw without router. But I called to mind about it almost at the end. And one more thing. When I cut it in bevel I forced to get back each inch and remove long chip. Because it falls inside and seize saw disc. I think I need to make split for saw disc or wider or contrary thinner. Here I cut triangle chip which trapped inside and prevent work of saw disc. I use such method. Cut a little and break, cut and break. My deal is came to finish. Inner parts of legs... need to insert on place. I very like this construction. I mean the principle. Glue very good keeps these porous surfaces. I tried to break some pieces for trials... of course I did it but... it holds very well. And when I made accurate angles I don't have any problems with coupling of details. How we can assume... preparing decides all. I need a bit press here. Main thing in gluing of this construction - don't press too much. A little to force glue get away and enough. Just a little bit here. And still legs dries we can glue their bottoms. If we put them here we can see whole beam. Even we look under table. I use PVA D3. It is a usual woodworking glue. I got too much here... but no matter… This process recall me my childhood when I was assembling plastic planes with father...such nostalgie… Quite resembled construction. And it is very light. I took it and easily carry from corner to corner. One more nuance. When all dried we can quite easy to remove remained glue by such wooden stick. Wery fast and don't scratch surface. And all what I can't remove by stich I can wash by wet duster. So... that's table I've finally got. It is my English translation of my old video