Hookah Bowl Packing Densities Explained | Fumari скачать в хорошем качестве

Hookah Bowl Packing Densities Explained | Fumari

Today’s subject has everything to do with hookah tobacco and its packing densities in your hookah bowl for the best results. But how can you make sure you’re packing your tobacco at the right density, isn’t hookah tobacco all the same? Don’t worry, as always, we gotcha fam. 0:20 Fluff Pack: 0% Density – Best with juicier, blonde leaf tobacco To fluff pack, you should be letting gravity do all the work for you. Simply break up your hookah tobacco by mixing it and allow it to fall from your fingers or fork directly into the bowl. From there you should re-adjust the leaves so they are under the rim but careful, compressing them even slightly will change the pack definition and smoke quality entirely. Typically, these packs smoke for a shorter duration and involve more heat management overall but can yield quite a tasty session, nonetheless. Fluff packing is even perfect for those quick sessions where you don’t want to waste a lot of tobacco. This method can be used for Fumari but we also like to give our leaves a slight tap down which leads us to the next density. 0:52 Normal Pack: 25% Density - Best with juicy or sticky, blonde leaf tobacco This type of pack follows suit right where the fluff pack leaves off and should be approached the same way, only this time tap those leaves in! To master a proper normal pack, fluff pack the standard amount of tobacco into your bowl but now you want to reduce the air gaps (fluffiness) between leaves and create a more uniform top layer by compressing the top layer. This should end up looking like 25% of your bowl is now compacted when you are finished. 01:17 Semi-Dense Pack: 50%-75% Density - Best with dark leaf tobacco or specialty blonde leaf tobacco To accomplish a semi-dense pack, start with just a little bit more tobacco than you normally would to keep your pack at the desired level. Fluff it in your bowl as usual but now you should continue past just compressing the top layer and focus on getting into the middle layer and part of the bottom layer. You want to minimize most of the air gaps here but not fully eliminate them. The best way to see this in action is to gently push down on your top layer once you are done and see if it springs back up, if it does not, you have likely done a dense pack and should rework your pack to have some more air gaps between the layers. 01:41 Dense Pack: 75% Density and beyond – Best with dark leaf hookah tobacco To achieve a dense pack, you should continue to compress the layers in your bowl until they are nonexistent. You don’t have to compact all the tobacco in at once and instead can focus on pushing down in a more controlled fashion. Keep in mind you want your pack below the rim however, as dense packing and overpacking are two completely different things. What’s important here is getting all your leaves uniformly compressed and arranged in a way that make them one opposed to the other methods we touched on where you still have air gaps remaining. To see if you did this correctly you can use the same method you used with semi-dense packing. Only now instead of looking for that bounce back from pushing the top layer down, look for little to no bounce from the tobacco. Now that you’re density and packing masters, let’s see some of those bowl packing shots! Be sure to tag us on Instagram for a repost and thanks for stopping by!