RVE Roller Shutter Lid Care Maintenance instructions скачать в хорошем качестве

RVE Roller Shutter Lid Care Maintenance instructions

With proper care and maintenance, the Roller shutter lid will provide many years of satisfactory operation. Although every care is taken upon installation to maximise weather resistance, the RVE shutterlid is not guaranteed to be waterproof. Warnings: Do not stand or place any heavy objects directly onto the RVE Shutterlid. There are options available with Roof-rack products that will allow carrying loads above the RVE Shutterlid. The RVE lids has a moving top cover, which poses a mechanical hazard – use with care. Do not load animals or humans under the RVE Shutterlid. Maintenance is required to maintain optimal performance of your RVE Shutterlid. Where possible, do not operate the RVE Shutterlid if water is puddled on top. Since the lid rolls onto itself, some water will get in contact with the bottom side of the shutters, which can drip inside the tray and be confused for a water leak. To open the RVE ELECTRIC Shutterlid: If water is pooled on top drive vehicle for several hundred meters to remove excess water before opening. Ensure manual lock is in “open” position. Press button on remote to open the lid. Pressing any button during the operation will stop the motion of the lid. To close the RVE Electric Shutterlid: Press button on the remote to close the lid. Turn rear lock to “closed” position. This will prevent the lid from opening by accidental remote button press. For extra security, the RVE Shutterlid can be locked with a key as well. To open the RVE MANUAL Shutterlid: If key-locked, unlock the lid. Turn the lock 90 degrees counter clockwise while still holding the strap, until the lid slides toward the front of the vehicle. Approximately one third of the way, the latch bolts will engage and stop the lid from fully opening. To fully open the lid, turn the lock 90 degrees counter clockwise again and let it slide fully open. * Note: Always hold strap while opening - do not let it slam open. To close the RVE MANUAL Shutterlid: With the tailgate open, pull the strap toward the tailgate with a smooth and even motion, until the latch bolts engage. Gently close the tailgate. For extra security, lock the unit by turning key clockwise 180 degrees. (Some wiggling of the lock ring may be required). CARE INSTRUCTIONS: As with anything mechanical, some minor maintenance is required from time to time. With normal use, check lid with every car wash, or once a month. Some friction and difficulty to achieve normal operation are usually a good indications that the lid is overdue for some TLC. A clean RVE Shutterlid, is a happy Shutterlid. Wash with car wash soap and car wax only. Do not use harsh solvents or other chemicals. Use a microfibre cloth to wipe dirt and dust from the siderail grooves. Generously apply silicone lubricant spray into the side rail grooves. Spraying while operating the lid (opening and closing) achieves good results. Check for and clear obstructions from the drain tubes. Pull drain tubes from the tray, then twist 90 degrees anticlockwise to remove from shutter lid cartridge. If there is any evidence of a blockage, have a bucket handy under these tubes Poke a round object (screwdriver, dowel, stick or similar) into the cartridge drain holes, to push away anything that may be blocking the holes. Inspect the tubes and remove any debris stuck inside them that could potentially inhibit drainage. Secure the tubes to the drain holes by twisting the tube connector 90 degrees clockwise into the Shutter Lid cartridge insert the other end of the tube through to holes in the tray. Regularly check that the lid is secured to the vehicle tray.