Setting Up An water-Cooled Grow Light—The Right Way! скачать в хорошем качестве

Setting Up An water-Cooled Grow Light—The Right Way!

G80 Grow light with water-cooling DIY is very simple Hello everyone, today we add water cooling to the G80 Grow light. With grow tent open on one side, the temperature rise of G80 Grow light is low, the temperature of the aluminum profile is 45 ° C, and the temperature of the plant surface is 30 ° C We closed the grow tent on all sides for the test. After 10 minutes, the temperature increased, the heat dissipation profile is 58 ° C, and the plant surface temperature is 33 ° C. If grow lights are turned on for a long time in the fully sealed grow tent, they would be damaged due to the high temperature. Now, we add a water-cooling system to the G80 Grow light. Firstly, we transfer the power supply to the outside of the tent with the extension cable. then Using a diameter of 8mm rubber tube, embedded into the back groove of the G80 aluminum profile. Both the inlet and outlet are placed in containers containing water. put the rubber tube into the water pump, and connect the water pump to the power supply to pump water for circulation. Re-close the tent. After 30 minutes, the maximum temperature of the aluminum profiles us 42 ° C, which decreased by 16 ° C. The cooling effect of DIY water cooling is very obvious, with it the G80 Grow light can be used in fully sealed grow tents. Due to strong illumination, the plant surface temperature of 34 ° C is a bit on the high side. In summer, the grow tent still needs to maintain air circulation to reduce the temperature of the plants You can also try DIY water cooling system! I am a grow light engineer, doing it myself and living a better life.