2003-2009 4Runner Neutral Safety Switch replacement (NSS) скачать в хорошем качестве

2003-2009 4Runner Neutral Safety Switch replacement (NSS)

I apologize in advance for the long video. This was a difficult project to replace the neutral safety switch located on the passenger side of the transmission on a Toyota 4Runner.  The four-wheel-drive system continue to flash, and the issues were stemming from the neutral safety switch; so I decided to replace it. STOP AND READ Be sure to clean off the end of the shaft with sanding cloth before beginning. This will safe lots of time later. This was a four hour job because I did not sand the end of the shaft well. After sanding and cleaning add penetrating lubricant and then use the slide hammer. I purchased part # 84540-51010 from a local Toyota dealer but used the link below to get 30% off and pick it up the next day https://parts.suburbantoyotaoffarming... Here is the 9 piece dent puller ABN Auto Slide Hammer 9-Piece Set, 5lb Pound – Puller Kit for Small Hail Dent Removal on Car Body https://a.co/d/8A1Efg5 Extension ABN Slide Hammer Extension Handle – 17.5 Inch Slide Hammer Adapter Steel Extension Bar CV Joint Puller Tool https://a.co/d/dCUiDVa I used a 5/8-18 fine thread rod and coupler from the local hardware store to extend the hammer. Leave comments below