How to Laser Engraving on Canvas? SCULPFUN S9, S30. Canvas Laser Engraving! Step by Step! скачать в хорошем качестве

How to Laser Engraving on Canvas? SCULPFUN S9, S30. Canvas Laser Engraving! Step by Step!

Laser Engraving on Canvas with SCULPFUN S9 5w & S30 pro 10W & S30 Pro Max 20W. Sculpfun S9-5w (6000mm/min 50%) Sculpfun S30 Pro-10w (6000mm/min 15%) Sculpfun S30 Pro Max-20W (6000mm/min 14%) 👉Purchase the Machine on Sculpfun Official Website: http://bit.ly/3ZDXd1j👈 Operation Steps: 1. Spray white paint on the canvas and dry it 2. Spray black paint on the white paint and dry it 3. Use the gradient diagram test to find the appropriate power 4. Select appropriate power for creation Matters needing attention: 1. During the first operation, use a canvas to test and carve. After being skilled, you can operate many canvases at the same time, saving the time for drying the paint. 2. The paint shall be sprayed evenly and the thickness of the same color shall be the same each time 3. The purpose of spraying white paint is to prevent the canvas from being penetrated. 4. For thicker canvas, white paint can be sprayed less or not. but the difficulty of carving will increase. 5. The black paint must be sprayed evenly, and a thin layer is enough 6. Please pay attention to dust prevention before the paint is dried. 7. For the use of gradient map, please watch my last video. The image mode of gradient map is grayscale.（   • Faster and Simpler: Laser Engraving Fast T...  ） 8. The side length of the canvas in the video is 150 mm, and the length of the test gradient map is 150 mm 9. The speed used in s9 is 6000 mm/min. For the convenience of calculation, the maximum power used is 75%, and the power used in creation is 50%. However, compared with the original image, this power may be too high. The image mode is dithering. 10. For the structure of S9, the speed of 6000 mm/min cannot guarantee the accuracy. It is recommended to reduce it to 4000mm/min 11.During the test, pay attention to the maximum power to prevent the canvas from being penetrated. 12. The speed of S30 pro - 10W is 6000 mm/min, the maximum power used in the test is 45%, and the power used in the creation is 15%. 13. The speed of S30 pro max - 20W is 6000 mm/min, the maximum power used in the test is 15%, and the power used in the creation is 14%. 14. Comparison carving effect, It is recommended to use drawings similar to the latter two types #sculpfuns9 #laserengraver #diycrafts ------------------------------------------------------------ 👉Facebook：   / sculpfunofficial   👉Facebook Official Group：http://bit.ly/42q5rwO 👉TikTok: http://bit.ly/3lKPdgZ (@sculpfunreal) 👉Official Website: http://bit.ly/3ZDXd1j 👉Instagram：  / sculpfunofficial   👉Twitter:   / sculpfuntech   ---------------------------------------------------------------- 00:00 Canvas Laser Engraving 04:02 Test Result