How to install moulding with an LED strip? - Ledkia скачать в хорошем качестве

How to install moulding with an LED strip? - Ledkia

Products featured in the video: UK - Buy here 🡪 https:/www.ledkia.com/uk/12033- IE - Buy here 🡪 https:/www.ledkia.com/ie/12033- FR - Acheter ici 🡪 https:/www.ledkia.com/fr/12033- IT - Compra qui 🡪 https:/www.ledkia.com/it/12033- DE - Hier kaufen 🡪 https:/www.ledkia.com/de/12033- AT - Hier kaufen 🡪 https:/www.ledkia.com/at/12033- CH - Hier kaufen 🡪 https:/www.ledkia.com/ch/12033- PL - Kliknij tutaj, aby kupić 🡪 https:/www.ledkia.com/pl/12033- NL - Hier te bestellen 🡪 https:/www.ledkia.com/nl/12033- BE - Hier te bestellen 🡪 https:/www.ledkia.com/be/12033- ------------------------------------------------------------------- 00:00 How to install moulding with an LED strip? 00:15 What do you need? 00:36 Required products 00:45 Pre-installation of lighting 03:30 Before you start 03:56 Fit the moulding 08:35 Fitting the LED strip ------------------------------------------------------------------- What do you need? Pencil. Mitre saw. Small tooth saw. Mounting adhesive. Tape measure. Silicone gun. Spatula. White paintable silicone. Pliers. Screwdriver/Drill. 6mm drill head. ----------------------- Required products: Moulding. LED strip. Power supply. Dimmer. Two-colour cable. Cable grommet. ---------------------------------- Before you start fitting the moulding Closed corner: 135º cut (left side) & 45º cut (right side). Open corner: 45º cut (left side) & 135º cut (right side). ----------------------- Steps to follow: Pre-installation of lighting Step 1: Decide in which position you are going to install the moulding. Step 2: Choose where to place the power supply and controller. Step 3: Drill a hole in the ceiling at the corner where the LED strip starts in order to pass the the connection cable to the mains. Step 4: Remove the recessed spotlight. Step 5: Pull out the power cable through the hole in the drill hole. Step 6: Place the power supply, dimmer and downlight into the hole of the downlight. Into the hole of the recessed spotlight. Step 7: Restore power. ----------------------- Fit the moulding Step 1: Lay out and cut out the first moulding. Step 2: Glue the first moulding. Step 3: Measure the wall and the width of the second moulding. Step 4: Cut the second moulding to the size of the previous step. Step 5: Glue the second moulding. Step 6: Measure the wall. Start from the last open corner to the next open corner. Step 7: Cut the third moulding to the size of the previous step. Step 8: Glue the third moulding. Step 9: Complete the rest of the walls. Step 10: Putty all joints with white paintable silicone. Depending on the type of moulding you have chosen, you will putty the joints in the ceiling or in the wall. ----------------------- Fitting the LED strip Step 1: Start laying the strip where the cables of the pre-installation are. It is recommended to use 12V/24V DC IP20 LED strips. Step 2: Glue the strip. Remove the paper from the adhesive and stick the strip slowly. Step 3: Connect the wires from the dimmer to the LED strip. Step 4: Restore power once you have finished the installation.