magic flight launch box/ da kube car adaptor for less than 15€!! скачать в хорошем качестве

magic flight launch box/ da kube car adaptor for less than 15€!!

This one is a working power adaptor plus some ideas for the battery-like-end, the chassis box, etc... You should be able to read electronics schematic, else you won't be able to built this. The reason why i didn't film the whole process is that without basic knowledge you might find it difficult to adjust/operate/troubleshoot. I didn't get it right from the begining either, which reminds me: I CANNOT STRESS THAT ENOUGH USE A PROTECTIVE FUSE You need aproximately 6A so any fuse from 8-10A should do! note the IDIOT at 00:50 who labeled the fuses I bought 10V (volts) instead of 10A (amperes)!! LOL *last minute change: instead of a 10K potentiometer, I used a 4.7K This will allow you to adjust the output alot easier, trust me **in the video I mention both mflb and dacube because I have both. my RESPECT to the mflb people who came up with a GENIUS idea, which is both a relief for my health and an inspiration to craft some accessories! (and common sense indicates that any new accessories should be tested on dacube first ;) COMPONENTS LIST: -------------------- 1 x LM317 (voltage regulator) 4 x 2N3055 (power transistors) 4 x 0.5 ohm/10 watts (fat resistors *the shop didn't have, so i used the equivalent 2 x 1 ohm/5w IN PARALLEL = 0.5ohm/10w) 1 x 270 ohms (resistor) 1 x 4.7 Kohms (potentiometer) 1 x car lighter plug (WITH FUSE!!) some "ΜΠΟΡΝΕΣ" (that's how they're called in greek...) , a spring or some fat wire and a beautiful product from Pattex henkel for quick repairs (a two components gum that hardens in 5 minutes) for the battery-like-end. optionally you can use those films that insulate electrically the transistors' collectors. Ι forgot to buy them but since all four collectors are connected i had less wiring to do!! downside is that now my chassis is at +12V LOL GOOD LUCK!! :)