Endura Pet Door Replacement Flap Tutorial for Doors and Walls скачать в хорошем качестве

Endura Pet Door Replacement Flap Tutorial for Doors and Walls

Ready to install your Patio Pacific Pet Door Replacement Flap? This video details the Endura Flap replacement for wall pet doors and door mounts. This step by step tutorial will ensure that you have the simplest installation experience as possible. Step 1: To replace your Endura Flap, first remove the hole covers. Step 2: Use a magnetic Phillips head screwdriver to remove the screws. Step 3: Before you replace your flap, be sure to take off the pivot washers. That way you can stretch out the bellows to ensure a better seal. Step 4: Now that the assembly that holds the flap has been removed, look at the side for a metal rod at the top of the frame. This is the rod that the flap hangs on. It may or may not have small, circular metal retaining rings on the end of the rod. If it does, remove them by forcing the ring off with a flathead screwdriver. You only need to remove one. You can then push the rod through the frame until it comes out on the other side. Step 5: You can now remove the flap. Step 6: Make sure that the magnets line up. Step 7: Guide the rod back through the flap and frame. Step 8: If you did have retaining rings, push the new ones on by holding one side of the rod in place with the pen while pushing the ring on with your finger. Each side only needs one ring. Make sure that before pushing on the retaining rings that you lay them on a flat surface to double check which side the teeth are facing. The teeth should be bent out facing away from the flap when installed. If they are put on backwards, they can fall off and cause a flap rod to gradually slide out. Step 9: The flap is now installed and you can reinstall the assembly into your door or wall. When installing, make sure that you tighten the screws until the weather stripping compresses and the pet door touches the door or wall. Do not over tighten. Step 10: Once the pet door is back in place, enter the hole covers into the frame using a non-metal tool. Step 11: Make sure that after the pet door is in place that you reseal it properly to prevent any weather damage. If you have any questions, you can call our customer service department. For more information about our cat and dog doors, go to http://www.petdoors.com or http://enduraflap.com/ Connect with PetDoors.com: Facebook:   / americasfinestpetdoors   Instagram:   / petdoors   Twitter:   / pet_doors   Google+: http://goo.gl/QFL1d Youtube: http://goo.gl/lxM2X Blog: http://www.petdoors.com/blog/ Pinterest:   / petdoors