У нас вы можете посмотреть бесплатно How to Replace the Cable on Flygt 3085 Pumps или скачать в максимальном доступном качестве, видео которое было загружено на ютуб. Для загрузки выберите вариант из формы ниже:
Если кнопки скачивания не
загрузились
НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием видео, пожалуйста напишите в поддержку по адресу внизу
страницы.
Спасибо за использование сервиса ClipSaver.ru
This is an informational video on cable replacement for Flygt 3085 pumps. This video is intended as a general reference for technical personnel tasked with maintaining pump performance and ensuring the replacement process is done safely and effectively. This video is NOT intended to serve as a step-by-step, fail-safe checklist. Projects vary and may require additional steps provided for in the Manual not included in this video. To learn more about Flygt 3085 pumps: https://www.xylem.com/en-us/brands/fl... Contact us here: https://www.xylem.com/en-us/brands/fl... Subscribe to our channel for more insights on how our innovative solutions are transforming water & wastewater management. Disclaimer Warning: Carefully review the product specific Installation, Operation and Maintenance manual (“Manual”) before tampering with the product in any way. All user safety rules and instructions contained in the Manual, as well as any other applicable safety rules, must be observed. This video is provided as general reference only, as a complement to the Manual, and cannot be relied upon as a substitute for professional advice. Failure to follow all instructions in the Manual may void the manufacturer's warranty. If there is a question or any uncertainty regarding the intended use or maintenance of the equipment, contact a Xylem representative before proceeding. Xylem cannot be held responsible for any actions or inactions undertaken as a result hereof. Timestamps: 00:00-00:14 Introduction 00:14-00:28 Loosen Cable Entry Gland Screw 00:28-01:11 Remove Stator Housing 01:11-01:35 Remove the Insulation Hoses 01:35-02:07 Disconnect Cable Power and Leads 02:07-02:35 Remove Cable, Washer, Seal Sleeve, Cable Clip & Grand Screw 02:35- 03:02 (If Cable Has Been Used) Peel Off Outer Sheath 03:02-03:25 Cut Leads 03:25-04:11 Fit Gland Screw, Cable Clip, New Seal Sleeve & Washer 04:11-04:36 Install the Cable 04:36-06:01 Connect the Leads 06:01-06:43 Fit the Cable Entry & Tighten Gland Screw 06:43- 07:11 Connect Ground Lead 07:11-07:45 Install Insulation Hoses 07:45-08:09 Replace O-Ring 08:09-09:09 Assemble Stator Housing #Flygt #ServiceVideos