У нас вы можете посмотреть бесплатно Why 1940s Factory Machines Ran 80 Years While Modern CNC Dies in 10 или скачать в максимальном доступном качестве, видео которое было загружено на ютуб. Для загрузки выберите вариант из формы ниже:
Если кнопки скачивания не
загрузились
НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием видео, пожалуйста напишите в поддержку по адресу внизу
страницы.
Спасибо за использование сервиса ClipSaver.ru
Why 1940s Factory Machines Ran 80 Years While Modern CNC Dies in 10 Industrial machinery manufactured from 1920-1950, particularly metal lathes, milling machines, and drill presses by companies like South Bend, Bridgeport, and Cincinnati Milling Machine, were constructed almost entirely from cast iron and hardened steel. A typical 1940s Bridgeport milling machine weighed 2,200 pounds, with the main column cast as a single 800-pound piece of Grade 30 cast iron—12-15 inches thick at critical stress points. The machine ways (sliding surfaces) were hand-scraped to within 0.0002 inches of flatness and made from hardened tool steel that was case-hardened to Rockwell C 58-62. These machines were designed to be rebuilt indefinitely. All bearings, gears, and wear surfaces could be replaced with standard parts. Companies like Bridgeport published repair manuals with complete engineering drawings, expecting machines to operate for 50+ years with proper maintenance. Modern CNC (Computer Numerical Control) machines use aluminum alloy frames to reduce weight and cost, with typical wall thickness of 1-2 inches. While computer control provides precision, the lightweight construction means less vibration damping and higher wear rates. More critically, modern machines use proprietary electronic components with 8-12 year obsolescence cycles. When the controller board fails after the manufacturer discontinues support, the entire machine becomes unusable scrap. Machine tool rebuilding companies report that 1940s-era manual machines brought in for refurbishment typically show minimal wear on critical components even after 60-80 years of industrial use. The same companies note that 2010-era CNC machines are often scrapped after 10-15 years not due to mechanical failure, but because replacement electronics are unavailable. A South Bend lathe from 1942 can still accept modern cutting tools and produce parts to aerospace tolerances, while a 2008 CNC machine may be worthless due to unsupported computer systems.