How to install a touchless sensor tap from hansgrohe - Focus, Metris and PuraVida скачать в хорошем качестве

How to install a touchless sensor tap from hansgrohe - Focus, Metris and PuraVida

0:00 Intro 0:04 Product Information 0:22 Content package & required tools 0:44 Installing the upper part of the mixer 1:29 Installing the lower part of the mixer 2:40 Wash basin cleaning Here we show you what to consider when installing a touchless basin mixer with mains connection and manual temperature setting. The video shows you all the necessary steps using the example of hansgrohe electronic faucets with connection to the mains, where the user can set the water temperature individually. See what you should know about the installation of the products shown and how best to proceed. You can find much more about e-faucets on the hansgrohe brand website. → 1. product information. Learn more about installing a touchless faucet using the example of the Metris, Focus and PuraVida lines of electronic basin faucets with mains connection and manual temperature control. → 2. scope of delivery and required tools. See here the supplied accessories for the installation of the touchless electronic faucet: two backflow preventers, the electric cable with plug for the power connection, the charger with the transformer and other accessories for the safe installation (fixing set). In addition, we show the tools you need. → 3. installation: upper part of the fitting. The electronic armature can be installed quickly with common tools. To note: The non-contact faucet should be placed close to the sink edge and the sensor should not be covered by any backsplash or bead on the sink edge. Insert the shaft of the non-contact faucet, along with the flexible hoses, into the drilled hole on the vanity where the e-faucet will be placed on the sink. We will show you how to fix the thread from below with a fastening ring by tightening the screws provided. → 4. installation: Now the video is about the lower part of the touchless electronic fitting, which is installed visually hidden from the user. First, the connections are mounted on the corner valves for cold and hot and connected to the flex hoses. Now it is necessary to connect the power supply for the electronic fitting. To do this, connect the cable coming out of the e-fitting with the hoses to the cable on the charger/transformer. Glue the small housing for the voltage converter to the wall. When the power supply is connected with the plug in the socket, the electronic sensor becomes active and automatically adjusts to the environment. To do this, allow a short waiting time before opening the water connections on the angle valves. → 5. washbasin cleaning. The water flow of the automatic, electronic faucet with mains connection should be de-activated for cleaning the sink, to do this, block the optical sensor for a few seconds. Simply hold a hand in front of the window for a short time for the infrared optics. The non-contact faucet is then deactivated for about 60 seconds, and you can wipe the inner surfaces of the sink clean without water flowing again in between. ► More about hansgrohe bathroom faucets: https://www.hansgrohe.de/bad/produkte... Also follow us here: Facebook:   / hansgrohe   Instagram: https://www.instagram.de/hansgrohe Pinterest: https://www.pinterest.de/hansgrohe Linkedin:   / brand-hansgrohe