Mitsubishi MR-J2-CT Commissioning. STEP 3 of 4. HOME SET 1st part. Origen Set скачать в хорошем качестве

Mitsubishi MR-J2-CT Commissioning. STEP 3 of 4. HOME SET 1st part. Origen Set

Part 1:    • Mitsubishi MR-J2-CT Commissioning. STEP 1 ...   Part 2:    • Mitsubishi MR-J2-CT Commissioning. STEP 2 ...   Part 3:    • Mitsubishi MR-J2-CT Commissioning. STEP 3 ...   (This video) Part 4:    • Mitsubishi MR-J2-CT Commissioning. STEP 4 ...   ​​​​​​​​​1) From the position page press the “far right” button and press “TURRET UNCLAMP”. VERY IMPORTANT: UNCLAMP the TURRET before proceed ​​​​​​​2) Move mouse cursor to lower left corner of screen, left click to get Windows start bar up. 3) Go to “Programs” 4) GO TO MR-J2-CT Setup Software ​​​​​​​5) Click on MR-J2-CT Setup Software when it comes up the second time 6) Left click on SETUP AXIS 7) Left click on AXIS SELECT 8) Select axis “TURRET” 9) Check in blue margin at top of screen to make sure correct axis was selected. 10) Open TEST OPERATION 11) Click OK to warning screen. 12) You must be in “Jog” in “Operation mode (R)” 13) Check the box “ABSOLUTE POSITON INITIAL SET (A)” 14) Left click on ORIGIN-SET(S) 15) Left click on NORMAL ROT, axis jumps to Z phase. Use REVERSE ROT. if linear axis 16) Numbers in MACHINE EDGE and POSITION should match 17) Close software and POWER CYCLE the machine (turn off control, turn off main breaker for 15 seconds) 18) After machine has rebooted, UNCLAMP the turret again 19) Go back to MR-J2-CT Setup Software​​​​​​​ 20) Change operation mode to REF.RETURN. 21) Press STOP (O) 22) Press REVERSE ROT(R) 23) Position window should show all zero 24) Initial set state window should show “Completion” 25) Close software, you are done. If you need to step axis to position: a) In TEST OPERATION under OPERATION MODE, select “Step” b) Select increment you wish to move axis, ie; .001mm/deg,.01mm/deg, .1mm/deg,1mm/deg. c) Left click stop to clear commands or when you change direction. d) Left click either NORM. ROTATION or REV. ROTATION to move axis into position. f) NOTE: Make sure turret is unclamped