How I make connections for power cords when I install fishfinders. скачать в хорошем качестве

How I make connections for power cords when I install fishfinders.

In the past, I have had crimped connectors fail at the worst times on the water so I developed a way that it doesn't happen again. In this video I'm going to show you how I make the connections on my power cords. The example used is a Lowrance power cord for HDS and Elite units, but the technique applies to all models. I am redoing a few of my power cords to get them ready for the new Lowrance products. The power cord will be connected to a fuse block. This is a long detailed video where I not only show you the steps in making up the connections but also a bit of why it is done that way. Hopefully you will learn from it and make your boating electronics experience better. Remember: Do it right, do it once. Products mentioned in the video (Amazon affiliate links): Ancor Heat Shrink Ring Terminals (select wire size and terminal size as needed): https://amzn.to/4gk5znN Ancor Butt Connector Kit: https://amzn.to/41DLCE5 Heat Shrink Assortment: https://amzn.to/3DknFHU Ancor 8 AWG duplex cable: https://amzn.to/3VwaTwd 6 Position Fuse Block: https://amzn.to/49IMGbR 30 Amp Breaker: https://amzn.to/4gf4ptP For your marine electronics needs visit: BassFishin Electronics: https://www.bassfishinelectronics.com/ DISCLAIMER: Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. There is no additional charge to you! Thank you for supporting my channel!