Dual Electronic Engine Control Lever IP68 (18): Side Parts (3) & Body (4) скачать в хорошем качестве

Dual Electronic Engine Control Lever IP68 (18): Side Parts (3) & Body (4)

Finishing the two side parts and the body by milling some radii … ↓↓↓ Complete description, time index and links below ↓↓↓ Last time we finished the levers by, amongst other things, milling a radius at one end (link below). Now we’re up to the big radii and one circular O-ring grove in the side parts and the body. These operations will get increasingly challenging. We start with the O-ring grove in the body and extending the shaft holes in the side parts. Then there’s some sawing to remove some material from the larger radii. Finally we mill those large outside radii on the side parts and the body. 00:00 Intro – radii on the big parts 00:59 Milled (1) – circular O-ring groove in body 05:13 Milled (2) – shaft hole extension in side part 08:12 Sawed – 45° corners off side parts and body 09:55 Milled (3) – 180° radius on site part 15:26 Milled (4) – 180° radius on body 25:27 Wrap-up – next time we put everything together, bye Dual Electronic Engine Control Lever IP68    • Dual Electronic Engine Control Lever IP68   Dual Electronic Engine Control Lever IP68 (1): Project Kick-Off    • Dual Electronic Engine Control Lever IP68 ...   … Dual Electronic Engine Control Lever IP68 (16): Round Table Setups    • Dual Electronic Engine Control Lever IP68 ...   Dual Electronic Engine Control Lever IP68 (17): Levers (3)    • Dual Electronic Engine Control Lever IP68 ...   #throttle #lever #ip68 #robertssmorgasbord