How to Set Up the Heating Element on the Ally Armour G164-HA Laminator | By Grimco скачать в хорошем качестве

How to Set Up the Heating Element on the Ally Armour G164-HA Laminator | By Grimco

In this video, we’ll walk you through the full process of installing and activating the heating element on your Ally Armour G164-HA laminator. From safety checks and hardware assembly to powering on and setting the right temperature, this step-by-step guide will help you get your machine heat-ready in no time. 🔧 Tools you'll need: • Phillips #2 screwdriver • Flathead screwdriver • Pliers • Snips • Gloves 🔥 What’s covered in this video: • Removing access covers • Inserting and securing the heating element • Connecting wires and ceramic end caps • Powering on and setting heater temperature • Pro tips for warming up rollers properly Be sure to check out our other Quick Start videos for setting up the air compressor and foot pedal. Thanks for choosing Ally Armour—your partner in productivity. Chapters: 0:00 Tools You'll Need for Install 0:36 Safety Tip: Make sure machine is unplugged 0:49 Remove access panels from both sides 1:10 Uncover wires and remove rubber gaskets 1:38 Unpack heating element from shipping tube and insert into machine 2:06 Pro Tip: Use a flathead screwdriver to lift heater over lip 2:27 Reassemble and connect wires to heating element on both sides 4:59 Reattach access panel covers 5:40 Power on machine and turn on the heater 7:28 Watch additional How-To videos to complete setup