Lifecasting Tutorial: How to Make a Hand Casting with Alginate скачать в хорошем качестве

Lifecasting Tutorial: How to Make a Hand Casting with Alginate

In this lifecasting tutorial video, we demonstrate how to use alginate to make a mold of a hand. Instructional Step One: Measure and Mix Mix Ratio: 1 part Alja-Safe to 1 part water by volume. Add first cup of Alja-Safe and begin mixing. Add second and third cups of Alja-Safe. Mix to a creamy consistency, no lumps. Step Two: Pose Hand and Immerse Slowing into the Alja-Safe Wet the model's hand before placing it into the Alja-Safe. Keep hand 1/2 inch (1.27 cm) above the bottom of the container. Let Alja-Safe set for 8-10 minutes, until solid. Step Three: Demold Slowly and carefully remove hand. Removing the model too fast may result in a tear in the mold. Ready to cast. Step Four: Casting into the Alja-Safe Mold with Smooth-Cast 300Q Ultra-Fast Urethane Resin Apply Universal Release Agent. Dispense Part A. Dispense Part B. Combine both parts in mixing container. Mix thoroughly. Rotate mold to minimize air entrapment. Plastic will cure in less than one minute. Step Five: Demold the Resin Casting Perfectly detailed reproduction. Apply primer. Apply paint. How long did it take to make the mold? Start to Finish: 25 Minutes How long did it take to make the casting? Start to Finish: 15 Minutes How much Alja-Safe was used? Less than 1 lb (0.45 kg) Use Your Imagination: Cold Cast Metal Effects Create Different Color Effects Clear Resin Effects (additional mold making & casting required) Starter Kit Available at: http://www.smooth-on.com/Getting-Star... Make It Now! with Smooth-On http://www.smooth-on.com/   / smoothon     / smoothon   http://www.google.com/+smoothon ~-~~-~~~-~~-~ Adult Supervision Required Keep Out Of Reach Of Children ~-~~-~~~-~~-~