IMPULSE® •Series 5 AC Variable Frequency Drives: Stationary Line to Line Resistance | CMCO скачать в хорошем качестве

IMPULSE® •Series 5 AC Variable Frequency Drives: Stationary Line to Line Resistance | CMCO

1. Introduction This SOP provides a step-by-step guide to perform a stationary line to line resistance Auto-Tune in IMPULSE®️ Series 5 drives. This option is available in the Auto-Tune section of a Series 5 drive programmed for vector control mode. 2. Procedure 2.1 An explanation of the Auto-Tune option Stationary Line to Line Resistance The stationary line to line resistance option in the Auto-Tune directory is used in applications where a previously successful standard-or-stationary Auto-Tune has been performed. The purpose of the stationary line to line resistance Auto-Tune is to measure a change in resistance when the festoon cable has been changed. NOTE: The motor will not rotate with a stationary line to line Auto-Tune. 2.2 Access the Auto-Tune Section First, hit the menu key and scroll down to Auto-Tune directory and open it up. 2.3 Select Stationary Line to Line resistance Auto-Tune (T01-01=2) 2.4 Complete remaining T01 parameters. 2.5 Start the Auto-Tune Press the green run key. The series 5 drive will energize and rotate the motor. On the Series 5 drive display, there’s a bar graph that indicates how far along the Auto-Tune is proceeding. The drive shows the frequency output and the current output. 2.6 Complete the Auto-Tune Upon completion of a successful Stationary Line to Line resistance Auto-Tune, the series 5 drive will show “End Tune Successful” on the display. 3. Conclusion This SOP provides a basic guide on how to perform a stationary line to line resistance Auto-Tune in IMPULSE®️ Series 5 drives. Always ensure to follow the steps in order to prevent any mishaps or further complications. Access more CMCO training from our Magnetek team here - https://motion.cmco.com/l/963023/2023... Full Series 5 Troubleshooting Video Playlist - https://motion.cmco.com/l/963023/2024...