У нас вы можете посмотреть бесплатно FIREBIRD DTF Starter Kit - DTF Made Easy или скачать в максимальном доступном качестве, видео которое было загружено на ютуб. Для загрузки выберите вариант из формы ниже:
Если кнопки скачивания не
загрузились
НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием видео, пожалуйста напишите в поддержку по адресу внизу
страницы.
Спасибо за использование сервиса ClipSaver.ru
https://www.firebirdink.com/dtf 1) Print onto FIREBIRD DTF Transfer Film Load the transfer with the matte side facing up. Tip: Always handle film by edges or corners. Print according to ink manufacturer's recommendations, or rip profile settings. Remove from platen and prepare for powder application. If recommended by your ink manufacturer, let the ink sit for at least 1 minute or hover press for 15 seconds, before adding powder. 2) Apply FIREBIRD DTF Powder Place printed film sheet onto the metal grid within FIRBIRD DTF Transfer Box. Add powder evenly across one end of the printed side of the film. Lift and allow powder to slowly and evenly slide across the entire sheet. Gently shake and tap the film from the back, to remove any excess powder. Note: Our films release the excess powder very easily, so you don't have to shake the film excessively. 3) Cure Powder onto Printed Film Cure FIREBIRD DTF Powder onto printed film at 300°F for 60-90 seconds on an IR conveyor, or use a heat-press to hover-cure for 4-5 minutes at 340°F. 4) Apply Finished DTF Transfer to Garment Place cured film with printed-side down onto your garment. Heat-press the film onto garment as follows: 100% Cotton or Cotton-Blend: Light to medium pressure for 8-10 seconds at 300-320°F. 100% Polyester: Light to medium pressure for 10-15 seconds at 280°F. Optional: Press again for 5-10 seconds with Teflon or parchment sheet cover. Remove garment from heat-press platen. Allow transfer to slightly cool down before peeling film, or let sit for cold-peel application.