KMi Onix скачать в хорошем качестве

KMi Onix

KMi onix Wingspan 650mm Length 580mm 3s and 4s 850 5x5 prop 40a esc Colorfabb LW-PLA-HT Polymaker HT-PLA ReadyToSky 2208 2300kv ReadyToSky 40a esc Tatu R-Line 850mah Zeee premium 4s 850mah Today was a maiden of a new micro racer series - KMi Onix. This was to match weight with the KMi Dawg and it made it. Coming in at 396g on 3s AUW. The 5x5 prop was still a good choice. As you can see from very first toss the throws were to high and wasn’t correct that easy. The 3s maiden i was on my standard low rates and it was still to high. But was very predictable once it got going. Before i went to 4s i did cut all my rates in half. This made it much more docile in flight. The length being 580 gives that legate much more authority. This could be brought in and will try the 550 again. I dialed the rates to far down when going to maiden this and didn’t have enough on launch. This did well with mid rate for launch and then switch to low rate for speed. The 4s test was much mother launch. It has a slight tendency to nose up with the added power; easily over counter. I do/did have strap fittings but the space inside was JUST enough for a 4s setup that they weren’t needed. For 3s i used some foam padding to fill. I am going to look to make a ratchet wall to put on the battery cover to hold things easily. Shouldn’t need the strap. This is going to be a good addition to the micro series! Go to https://kmi3dprint.com for the beta or watch for the release!