Stihl ms200t dismantling and rebuild part 6 - assembly скачать в хорошем качестве

Stihl ms200t dismantling and rebuild part 6 - assembly

If you are looking for aftermarket chainsaw parts, please support my channel by buying from: http://www.hlsproparts.com/?Click=48376 Disclaimer: ladies and gents, this is a CHAINSAW, working with, building and fiddling with these can KILL YOU, I am not and will not be responsible for improper technique or accidents even remotely relating to this video, please view for entertainment purposes only. This video is the assembly from the crankcase/cylinder head on up to the gas tank. P PLEASE NOTE: make SURE the ignition coil is installed after the flywheel and pay special attention to the small black wire which runs along with the ignition wire. this wire goes UNDER the ignition wire in a channel that's near the flywheel and then clips to the ignition coil itself. also, DO NOT attempt to put the muffler or intake boot on before you put the gas tank on, just a waste of time. the oiler DOES go over the ignition coil wire all of this is explained in the video, but I wanted to reiterate it here. thanks to JUTTREE on arboristsite.com ... "The supporting plate or mounting plate for your intake boot is on upside down. Also, make sure that the intake boots tab is lined up against the tab on the cylinder, not on top of it but against the side or you'll have a fun time getting things to line up properly." so yeah, I think I have the plate upside down. it seems to work fine, but still, nice to know the proper way finale is here!    • stihl ms200t rebuild part 7 finale , carbu...