How to mount an Evo Shearing Plant to a wooden board скачать в хорошем качестве

How to mount an Evo Shearing Plant to a wooden board

How to correctly hang an Evo Shearing plant using the template provided. 1. Begin by measuring 20cm in from the porthole. 2. Next, refer to the included template for the hang height and measure this from the ground. 3. Mark both this height measurement and the edge as measured from the porthole earlier. 4. Line the template up with these two markings, ensuring it is straight. 5. Place a nail at each of these points and hit with a hammer, this will mark the wood. 6. Remove the template and line the Evo bracket up with the marks you just made on the wood. 7. With all points lined up, mark the two holes at the very top of the bracket. 8. Drill these two holes. 9. Next, screw the Evo bracket to the board using these same 2 holes. 10. It is very important that you then use at least ONE large bolt like this to attach your Evo. 11. This large bolt can be safely placed through any of these holes. 12. Next, line the two holes at the top of the Evo up with the two holes at the top of the bracket. 13. Slide the included bolts through and do them up tightly. 14. Finally, feed the rope through the loop on the side of the Evo, bend it back on itself and fit firmly using two cable ties. Your Evo is now safely mounted and ready for use.