How To Use Protostrap | 3D Printed Battery Strap for FPV drones and RC hobbies & Free Download Link! скачать в хорошем качестве

How To Use Protostrap | 3D Printed Battery Strap for FPV drones and RC hobbies & Free Download Link!

Links to Purchase! Protostrap S / MS https://www.protofpv.com/product-page... Protostrap M https://www.protofpv.com/product-page... --- Hey guys! Thanks for checking out the video! Protostrap was born out of sheer boredom while my kids were at a four-hour-a-day spring break swim camp. Picture me just sitting there with my sketchbook, trying to think of ways to avoid making more stuff in China LOL If you've got a 3D printer, give it a try! Takes some getting use to, but it works. It's still super lightweight too! Use two straps if necessary. If you enjoyed the video, please like, subscribe, share the word about PROTOFPV. and check out my website www.protofpv.com --- PROTOFPV STL files are strictly for personal use only. PROTOFPV STL files are not to be used, remixed, or replicated for the purpose of resale or commercial use without PROTOFPV’s written permission. If you have any questions, please contact [email protected] for more information. --- *Notes and Warnings: Make sure you watch the full video before attempting to use protostrap. PARTS 1) Protostrap comes in two parts. Strap and Loop. 2) Protostrap S Fits Minimum Size Lipo: 32mm W x 24mm H Maximum Size Lipo: 54mm W x 32mm H Protostrap MS Fits Minimum Size Lipo: 32mm W x 24mm H Maximum Size Lipo: 54mm W x 32mm H Protostrap M fits Minimum Size Lipo: 32mm W x 24mm H Maximum Size Lipo: 54mm W x 32mm H PROTOSTRAP L 3) Protostrap L is untested and unproven. Was designed for 4000mah L-ions + to fit future LR frames. Use at your own risk. I may revise in the future to be wider and thicker. WIDE PROTOSTRAP P5G 4) Wide Protostrap P5G is designed for a future protofpv tank frame, but go ahead and try it. :) It is untested and unproven. Was designed for most 6S 1000 ~ 1500mah. Extra wide so you don’t need to use two straps! I may revise in the future, the hole in the middle is too long. COLD AND WARM CLIMATES 5) TPU gets stiffer in cold days or more elasticy during warm days, so just make sure it's always nice and tight. Don't assume and count on using the same hole in the strap. FLOW RATE 6) Besides having good print and temp settings, I found the most important setting for protostrap is to set your flow rate to 110%. This will make everything thicker and stronger. --- Downloads https://drive.google.com/drive/folder... --- Recommended TPU Settings for Protostrap only: TPU Hardness: 95A Flow Rate 110% - Very Important 25% infill or more Rectilinear Fill Pattern Primary layer height 0.25 Line Width 3.5mm Initial Layer Line Width 110% Top solid layers 4 Bottom solid layers 4 Nozzle Temp 200 Heated Bed 50 Retraction 1.5mm Speed 30mm/s --- 0:00 Intro to Protostrap 0:46 Design, Outside & Inside areas 1:38 How to use the strap 2:30 How to NOT use the strap! ---