OpenRC F1 3D printed RC car review and test drive скачать в хорошем качестве

OpenRC F1 3D printed RC car review and test drive

Hello everyone, here is the full video of my OpenRC F1 car. I spent one full week printing this and finally I had a chance to drive it.However with 3D printed TPU tires the car was barely drivable due to the low grip and understeering. Everyone suggests that Tamiya F104 tires will do the job but I don't think it's worth to buy them for this car unless you already have them. Anyway it was a cool project to build, I doubt I will drive it again unless I find proper tires but we will see. As I said in the video, I've used PLA at 20% infill for all of the parts except the tires. Full list of parts needed to build the car: 23 - M3 Nuts 31 - M3x8 Countersunk Screws 1 - M3x10 Countersunk Screw 3 - M3x12 Countersunk Screw 3 - M3X8 Pan Head Screw As you saw in the video I've used whatever screws I had and not really the official guide ones. 2 - 6701 high speed bearings 12x18x4mm 4 - MR128 high speed bearings 8x12x3.5mm MG90S Servo motor with metal gears (Please do not use plastic gear servo for RC cars) 60A Brushed ESC 540 35T Brushed Motor 2S 7.4V 1800mAh LiPo battery Remote control system (I've used my FlySky GT-3B) TIMESTAMPS 0:00 Intro 0:07 Few words 0:35 Floor and other parts 0:52 540 35T Brushed motor and gears (not really a differential) 1:03 MG90S Servo motor and steering rod 1:13 Tires 1:38 60A ESC 1:49 2S 7.4V 1800mAh battery 1:59 Some nice photos 2:18 Test drive 8:30 Donuts 9:00 Rear wing view 9:48 Side pod view 10:48 Closing Credits to Daniel Noree the designer of this car for his amazing work. Check out his youtube channel for full build instructions. Daniel's website - https://danielnoree.com/ His thingiverse page - https://www.thingiverse.com/barspin/d... His youtube channel -    / danielnoree   Shot mostly on GoPro Hero 8 Music - "Summer" by Bensound http://www.bensound.com