How to Disassemble Flygt 2800 Series Pumps скачать в хорошем качестве

How to Disassemble Flygt 2800 Series Pumps

This is an informational video on pump disassembly for the Flygt 2800 pump series. This video is intended as a general reference for technical personnel tasked with maintaining pump performance and ensuring the replacement process is done safely and effectively. This video is NOT intended to serve as a step-by-step, fail-safe checklist. Projects vary and may require additional steps provided for in the Manual not included in this video. In this video, we will walk you through the disassembly process of the Flygt 2800 series pumps. For more resources and detailed information about the pumps: https://www.xylem.com/en-us/products-... Contact us here: https://www.xylem.com/en-us/brands/fl... Subscribe to our channel for more insights on how our innovative solutions are transforming water and wastewater management. Disclaimer Warning: Carefully review the product specific Installation, Operation and Maintenance manual (“Manual”) before tampering with the product in any way. All user safety rules and instructions contained in the Manual, as well as any other applicable safety rules, must be observed. This video is provided as general reference only, as a complement to the Manual, and cannot be relied upon as a substitute for professional advice. Failure to follow all instructions in the Manual may void the manufacturer's warranty. If there is a question or any uncertainty regarding the intended use or maintenance of the equipment, contact a Xylem representative before proceeding. Xylem cannot be held responsible for any actions or inactions undertaken as a result hereof. This video has no sound 00:00-00:34 Introduction 00:34-00:48 Remove the Discharge Connection 00:48-01:47 Mount M12 & Lift Pump 01:47-02:06 Place Pump Horizontally 02:06-02:31 Remove the Strainer & Shock Absorbers 02:31-02:47 Remove the Inspection Plug 02:47-03:15 Remove the Lower & Upper Oil Plug 03:15-03:30 Drain the Pump 03:30-03:56 Re-fit the Plugs 03:56-04:07 Remove the Lifting Handle 04:07-04:47 Fit Eyebolt and Lift Pump Upside Down 04:47-05:12 Untighten & Remove Impeller Screw 05:12-05:31 Loosen the Impeller 05:31-05:43 Remove the Suction Cover 05:43-05:54 Remove the Impeller 05:54-06:16 Remove the Diffuser 06:16-06:50 Remove Oil Housing Bottom 06:50-07:07 Remove the Mechanical Seal 07:07-07:34 Remove the Intermediate Piece 07:34-07:59 Lift Out the Rotor Unit 07:59-08:20 Lift and Turn Pump 08:20-08:39 Remove the Junction Box Cover 08:39-08:59 Remove the Terminal Board 08:59-09:12 Disconnect the Stator 09:12-09:40 Remove the Junction Box 09:40-10:07 Remove the Outer Casing #Flygt #ServiceVideos