Making Colloidal Silver Using a DC power supply. скачать в хорошем качестве

Making Colloidal Silver Using a DC power supply.

How to make a very fine particle colloidal silver. When I first started to make it I used the water cold and much of the silver would just fall to the bottom of the jar and looked like the bottom had been silver coated. I tried heating it in a regular pan of water while making it and the bottom of the mason jar apparently got too hot and the bottom broke off so I moved to a double boiler and have had good luck ever since. I always test my distilled water when I begin using a PPM (parts per million meter) you can get one fairly reasonable at amazon. (HM Digital TDS-EZ Water Quality TDS Tester, 0-9990 ppm Measurement Range, 1 ppm Resolution, 3% Readout Accuracy) for around $16.00. I also use an led laser pointer to look at the particle size. It should look as close to a solid beam as possible. Any red laser works fine. I use steam distilled water as I have found reverse osmosis distilled water has many ppm of something in it while steam distilled measures 0 ppm consistently for me. I like to start out with 0 ppm then when I am making it with pure .9999 silver wire that will be all that is put into the water during the process. I always purchased my silver wire from amazon seller lifeforce devices. 40" Colloidal Silver Generator Wire 9999 Pure 10 Gauge by LifeForce Devices This is currently unavailable but I am sure you can still purchase pure silver wire somewhere. I recommend 10 awg any smaller will be used up too quickly. 2 - 6 inch pieces will make many gallons of colloidal silver. I use a DC power supply but you can also us 3 9 volt batteries connected end to end positive of one battery to the negative of the next battery. Then use the positive and negative of the two end batteries as your power source. This will give you approximately 27 volts DC. The flow of electrons is termed electron current. Electrons flow from the negative terminal to the positive. Conventional current or simply current, behaves as if positive charge carriers cause current flow. Conventional current flows from the positive terminal to the negative. Therefore you need to change the connections to the silver wires periodically. I do this about every 15 minutes. This will ensure that your two silver wires will remain approximately the same diameter of each other. (Move the positive lead to the silver wire that had the negative lead on it and move the negative lead to the silver wire that had the positive lead on it.) Otherwise all the silver will be removed from the wire that the negative lead is connected too. You can purchase what is called a colloidal silver generator. Some have a voltage switcher built in besides a power supply. So many different ones out there, I can't recommend any of them. All are rather expensive. The biggest cost I have is the silver wire. But for the amount of Colloidal Silver you can make with just 2 - 6 inch pieces is unbelievable. Gallons of it. I am now using 2 quart mason jars to make my colloidal silver. What I have used it for: Prevention of colds and flu. Healing of all types of cuts, abrasions, burns, deep puncture wounds. Itching ears, eyes. Nasal congestion, Dripping Nose, sore throat. Disinfectant. It is known to kill hundreds of different pathogens and viruses. I also posted a Q & A COLLOIDAL SILVER text video.