Скачать с ютуб How to pair a TERADEK BOLT and add a second Receiver в хорошем качестве

How to pair a TERADEK BOLT and add a second Receiver

In this video, Greg goes over the process of pairing Teradek transmitters and receivers and adding in multiple receivers to have separate monitors with the same signal. Setup Steps: 1. Get the power to both the transmitter (TX) and receiver (RX) 2. Run an SDI or HDMI cable from the camera to TX 3. Run an SDI or HDMI cable from RX to a monitor. 4. Power on both TX and RX 5. On the RX press the joystick to the right to open the menus on the monitor 6. Use the joystick to navigate down to the PAIRING option 7. Press the joystick in to select 8. On the TX use a paper clip or some other small item to press the pairing button on the TX found at: 9. Back on the monitor, you’ll get notified then the RX has found the TX once it has select OK 10. Once the pairing is complete you should have the video on your monitor! 11. To add a second RX turn on the second RX and just repeat steps 5-10 Gear in this video Teradek BOLT 500: http://bit.ly/2rqCJKv Other Teradek Option: http://bit.ly/38oaukc SmallHD 702: http://bit.ly/2GggQWC Outro music from ArtList IO - http://bit.ly/GregArtlistio - Get 2 months FREE! Stay up to date! Instagram ►   / lensprotogo   Facebook ►   / lensprotogo   Twitter ►   / lensprotogo   LensProToGo ► https://www.lensprotogo.com Greg ►   / gregfarnum