SLX How To #3 - Initial Setup скачать в хорошем качестве

SLX How To #3 - Initial Setup

SLX Foamers and Sanitizer sprayers and cleaning equipment by Clean Logix. In this video, we'll explain how to set up the SLX system for the first time before normal operation. When operating the foamer for the first time some alterations may need to be made to produce the desired foam quality and ensure the unit is drawing chemistry as intended. 1. Ensure unit is properly connected and supply valves are closed. 2. Take hold of the spray wand. 3. Open ball valve on spray wand. 4. Fully open water or pump supply valve. • The spray wand will slowly begin discharging water. • For Venturi/Water driven models - Chemicals will be drawn up the suction line and introduced to the fluid path. 5. Ensure water pressure is above 35 PSI 6. For foamers - Fully open air valve. • There will be a kick of pressure as the spray wand recoils from the air pressure. 7. For foamers - Foam will begin to initiate. • This may appear uneven at first but as the air and water pressure stabilize the quality of the foam will become more uniform. 8. For foamers - To alter foam consistency adjust the air pressure: • Dryer Foam - Increase air pressure (turn dial clockwise). • Wetter Foam - Decrease air pressure (turn dial counter-clockwise). 9. Check foam or spray quality and dilution amount per facility standards. 10. For Venturi/Water driven models - Metering tip size may need to be changed if foam quality or dilution ratio is still not adequate (see Dilution Video:    • SLX How To #2 - Chemical Dilution & Meteri...  ) For more support: https://www.clean-logix.com/slx-suppo...