A satisfying setup of the RS3M Maglev скачать в хорошем качестве

A satisfying setup of the RS3M Maglev

In terms of what the final cube feels like, it feels really similar to my 5x5 which has also been core-magged. Comparing the core-mag RS3M to a Meilong3 is like comparing a core-mag Aochuang WR to a Valk 5. The RS3/Aochuang boasts a lot more flexibility and feel less rigid and snappy than the Meilong3/Valk5, but on their own, also less stable. Core magnets however, add a lot to the stability but only add very little to the magnetic snap, producing a stable puzzle with very fluid transitioning between turns. A note regarding polishing: Metal polish uses microabrasive particles to smoothen a rough surface, and some of it may seep between the pieces. You don't want the metal polish grinding your internal mechanism away, and therefore, you should not turn the puzzle during or after polishing. I would recommend doing a full disassembly and cleaning the puzzle piece by piece, before you attempt to turn it again. Angstrom lubes uses microabrasive particles as well, but it's a different grade (likely much less abrasive). It's not effective for grinding a frosted surface into a glossy one but it's good as a lube. A note regarding the magnetic core: If you don't have a 3d printer you can use the epoxy sculpt method that I did to my Aochang WR and Aoshi GTS. It should work fine for the core. 3x3 corner bases however, have a bigger cavity than 5x5 or 6x6 corner bases. You may want to fill 80% of the cavity first, with something light like foam/crushed paper, then add some superglue to harden it, before stuffing epoxy in. Alternatively (and much more easily), Cuber's home already made core-mag conversion kits for the RS3M, and tutorials on how to use the kit already exist. The print that was shown in the video was a test print. Usually I would print one of each piece type first and see if the printed part could carry out it's function or needed any design tweaks, then proceed with the main print, which is something I couldn't do with my SLS puzzles. A note regarding my lube choices: It's basically Cubehead's Yoo lube bundle but with some substitutions because have a lot of lubes that have similar functions to his combo, but are not the exact lubes. There are 4 main ingredients to this lube combo: 1. Angstrom dignitas (no change) 2. Standard silicone (this was the only intentional change. Used wt 3 instead of wt 5 because I initially tried this combo on several big cubes such as my Aochuang, Spark and Diansheng8. Liked the lower viscosity and the ability to mostly bypass the 'gummy phase' which happens after you don't play with the cube for a while) 3. Fancy Silicone (didn't have mystic. Initially tried substituting with silk, but eventually switched to speedy since I like my cubes fast) 4. Water lube (I actually have DNM, but I have a much larger quantity of Justlube shadowless kick, so I used it instead) 0:00 Polishing and cleaning 2:14 Magnetic core 6:49 Tensioning 7:39 Lubing 8:14 Test solve