In-Hull Transducer – A good method for a not so good idea скачать в хорошем качестве

In-Hull Transducer – A good method for a not so good idea

s05e31 This is an old project that I ended up abandoning on advice from Airmar. I think the process I followed is worth knowing but other than that, it is only of academic interest. Because I’m not around to do a video this week I have scheduled this one to go public on the weekend. I wanted to fit a 1kw transducer to my boat with a view to deep drop fishing. There is not a lot of room left on the transom and a through hull unit would be difficult to fit so I thought I would use an in-hull transducer. The only place I could mount the transducer was on a particularly uneven bit of hull which was going to be very difficult to cut the transducer box to fit, so I had to think outside the box to figure out how to do it. This video is about that. After I had everything prepped so that I could fit the transducer box, but before I purchased the transducer, I checked with Airmar to get their opinion of my mounting plan. That was where my idea came unstuck. Airmar believed that mounting the transducer over the hull tunnel was likely to get too much interference from tiny air bubbles to be effective. I was left with no option but to scrap that idea and figure out a way to do a transom mount. Never-the-less, as an idea I think this is gold, even though I did not use it in the end I took the experiment far enough for you to be able to assess if it will work in your case. ▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ Buy online: ▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ Silicone Mould Mix: (white) https://ebay.to/3lPf4Po (blue) https://ebay.to/35cUOQS Plasticine: https://ebay.to/35cUD8t ▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ Follow weFish-AU on: ► FishTrax: https://fishtrax.we-fish.com.au ► Facebook: https://fb.me/wefishAU ▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬