CNC Tutorial - Touch Probe in Mach 3 скачать в хорошем качестве

CNC Tutorial - Touch Probe in Mach 3

Not my work, but this shold be a good starting point for most folks. PlateThickness = GetUserDRO(1151) 'Z-plate thickness DRO If GetOemLed (825)=0 Then 'Check to see if the probe is already grounded or faulty DoOEMButton (1010) 'zero the Z axis so the probe move will start from here Code "G4 P5" ' this delay gives me time to get from computer to hold probe in place Code "G31Z-40 F500" 'probing move, can set the feed rate here as well as how far to move While IsMoving() 'wait while it happens Wend ZProbePos = GetVar(2002) 'get the axact point the probe was hit Code "G0 Z" &ZProbePos 'go back to that point, always a very small amount of overrun While IsMoving () Wend Call SetDro (2, PlateThickness) 'set the Z axis DRO to whatever is set as plate thickness Code "G4 P0.25" 'Pause for Dro to update. Code "G0 Z25.4" 'put the Z retract height you want here Code "(Z axis is now zeroed)" 'puts this message in the status bar Else Code "(Z-Plate is grounded, check connection and try again)" 'this goes in the status bar if aplicable Exit Sub End If