Using our New 5th Gen QuickTrick QuickString 4 head alignment tool for the 1st time! скачать в хорошем качестве

Using our New 5th Gen QuickTrick QuickString 4 head alignment tool for the 1st time!

Installing our New QuickTrick Alignment Tools - ALSS 5th Gen QuickTrick 4 head QuickString alignment tools for the 1st time! Installing the heads is the same as the old system, install the fingers to the wheel, tension then tighten the adjuster, and install the bungee to ensure they stay put. The new 4 head set up uses 2 rulers on each head, so install the heads so that the slotted rulers are to the outer corners of the vehicle, this is where you will be putting the string into. This will now allow you to draw the string over all 4 rulers and now you have your easy point of reference for adjusting your toe. This is definitely nicer than the old system with the 2 tape measure because now you have a scale on each side so the toe on each side is just a direct read rather than a split. I found that care and attention should be taken, you definitely don't wanna be "Rammy". When storing the tool, remove the fingers and reinstall the nuts that came with the tool, the new aluminum tubes have some sleeves and washers inside that you want to keep in place! I'm looking forward to getting more familiar with the New 4 head QuickString set up!