У нас вы можете посмотреть бесплатно Affreschi & Affreschi - Installation of a mural made of 3 panels или скачать в максимальном доступном качестве, видео которое было загружено на ютуб. Для загрузки выберите вариант из формы ниже:
Если кнопки скачивания не
загрузились
НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием видео, пожалуйста напишите в поддержку по адресу внизу
страницы.
Спасибо за использование сервиса ClipSaver.ru
Now you will see the installation of a mural made of 3 panels. During the installation you need: vinylic glue 2 plastic spatulas a tape measure a level a cutter some paper tape a pasting brush a brush 2 ladders Make sure the wall is clean. Before the installation takes place, we reccomend to apply a wall fixative. You should start the installation of the fresco from the central piece, after that you can carry on with the installation of lateral panels; this will help you to have a perfectly aligned design. First of all plumb the wall then you can proceed applying the glue gradually, considering the height of the wall and the external temperature. If the external temperature is too high, the glue could dry very soon. You should unroll the fresco from up to down, applying pressure with the polystyrene cylinder and using the plastic spatula; like that the mural will not only adhere better to the wall but you will also prevent the creation of air bubbles. After you install the first panel and before installing the others, we suggest to put some paper tape on the one you have already placed to protect it. Paper tape will be removed once the application of the glue to paste the other segment is over. Be careful and do not put too much glue where joints are located, otherwise it may overflow. During the installation, switch on a strong light and check the fresco surface to see if there is any air bubble. If so, you can remove it using a plastic spatula or with the tip of a cutter. If you realise the creation of air bubbles is due to the lack of adhesive, you can inject some glue with a syringe. In case you see there is a microdifference in thickness between two panels, you can put a piece of wood on the joint and beat with a hammer. To perfection lovers we remind our frescoes are a handcrafted product so there could be some small difference in alignment; in this case it will be enough to use a pencil or some pastel pencils to correct details. For further information, do hesitate to contact us.