Changing Audi A3 rear wheel bearing, brake discs, pads and caliper (8PA model code) скачать в хорошем качестве

Changing Audi A3 rear wheel bearing, brake discs, pads and caliper (8PA model code)

This 2009 Audi A3 (8PA model code) had noisy rear wheel bearings, so I decided to change them. I also changed the rear brake discs and pads at the same time as they were ready for doing. Just for good measure the caliper on the side I chose to video was stuck, so it got a new brake caliper too! This car had covered 184,000 miles. I started by jacking the car up and supporting it with axle / jack stands. After that I removed the road wheel and unbolted the brake caliper from its slider pins. This enabled the brake pads and brake disc to be removed. The wheel bearing unit is held in place by a single bolt, which requires a M18 12 point / XZN / triple square bit. It's tight! With the new wheel bearing unit and brake disc fitted, the time came to retract the brake caliper piston to accommodate the new brake pads. The piston was stuck so it was time for a new caliper. It is possible to refurbish the existing caliper but I didn't have time for that on this occasion. I swapped the short brake line from the old to the new caliper and installed it on the car. Next it was time to bleed the air out of the new caliper and I used a pressure brake bleeder to help with this. Finally the new brake pads could be installed, then it was time to put everything back together and take it for a test drive. Success! Tools M18 triple square / 12 point driver. Long breaker bar T30 torx bit and driver 10, 13, 15 and 17 mm spanners / sockets 11 mm brake line spanner https://ebay.us/9m151l Pressure brake bleeder https://amzn.to/3nzUp3H Wire brushes https://amzn.to/34W8Zeg Jack and axle stands Parts Wheel bearing FAG 713 6109 60 Brake pads Textar 2355402 Brake discs Textar 92120903 Brake caliper Apec RCA235N Brake fluid Sections 0:00 Introduction 1:33 New parts 2:26 Noise from old bearing, wheel on 3:02 Wheel removal 4:03 Undoing brake caliper 6:06 Removing brake disc 7:01 Bearing noise with disc removed 7:24 Removing wheel bearing assembly 11:36 Fitting new wheel bearing assembly 17:28 Cleaning brake pad carrier 19:58 (Attempting to) retract caliper piston 22:22 Removing brake caliper 27:25 Fitting new brake caliper 36:18 Fitting new brake disc 37:50 Fitting new brake pads 41:09 Finishing up 41:58 Ending Link to download Audi manuals: https://erwin.audi.com/erwin/showHome.do #audia3 #brakes