Скачать с ютуб How to Heat a Garage Workshop | Ask This Old House в хорошем качестве

How to Heat a Garage Workshop | Ask This Old House

Ask This Old House plumbing and heating expert Richard Trethewey travels to Akron, Ohio to install a garage heater. SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Richard installed the High Intensity Radiant Workshop Heater, manufactured by Mr. Heater [https://www.mrheater.com/]. Time: 3-4 hours Cost: $500 Skill Level: Expert Tools List for Heating a Garage Workshop: Drill driver Pipe cutters Shopping List: Radiant Workshop Heater Lag bolts Washers for bolts Spade bit Drywall screws Flexible gas line Gas pipe fittings Gas pipe in various sizes Pipe dope Vent Thermostat Steps: 1. Working with gas is extremely dangerous and should only be left to a licensed professional. 2. Shut the gas off at the meter. 3. Determine a location to mount the heater that’s easily accessible to the gas line. To give the heater more range, try mounting it in a corner. 4. Mount the bracket for the heater to the chosen location using bolts and a drill. Be sure to follow the instructions to ensure proper clearance from the walls and ceiling. 5. Slide the heater onto the mounting bracket and secure it with nuts that come with the heater. 6. Drill a hole into the wall or ceiling using the drill with a spade bit to connect the gas piping. 7. Screw the mounting bracket provided with the heater into the wall or ceiling using the drill and some drywall screws. 8. Connect the flexible gas line to the existing gas line and then pass it through the bracket. 9. Thread the fitting and brass connection that come with the heater onto the flexible gas line and then screw the fitting onto the bracket. 10. Connect the flexible gas line to the heater using a variety of gas pipe, fittings, elbows, and nipples. Use pipe dope to secure all the connections. 11. Drill a hole on the other end of the garage and install a vent to ensure there is another air flow to allow exhaust to escape the room. 12. Connect the thermostat to the heater and attach it to the wall. 13. Turn the gas back on. Resources: The other materials Richard used to install the heater, including the gas piping, the flexible gas line, and the plywood to hold the bracket for the heater, can all be found at home centers. Expert assistance with this segment was provided by Echols Heating and Cooling (http://echolsheating.com/) About Ask This Old House TV: Homeowners have a virtual truckload of questions for us on smaller projects, and we're ready to answer. Ask This Old House solves the steady stream of home improvement problems faced by our viewers—and we make house calls! Ask This Old House features some familiar faces from This Old House, including Kevin O'Connor, general contractor Tom Silva, plumbing and heating expert Richard Trethewey, and landscape contractor Roger Cook. Looking for more step by step guidance on how to complete projects around the house? Join This Old House INSIDER to stream over 1,000 episodes commercial-free: https://bit.ly/2GPiYbH Plus, download our FREE app for full-episode streaming to your connected TV, phone or tablet: https://www.thisoldhouse.com/pages/st... Follow This Old House and Ask This Old House: Facebook: http://bit.ly/ThisOldHouseFB Twitter: http://bit.ly/ThisOldHouseTwitter http://bit.ly/AskTOHTwitter Pinterest: http://bit.ly/ThisOldHousePinterest Instagram: http://bit.ly/ThisOldHouseIG http://bit.ly/AskTOHIG For more on This Old House and Ask This Old House, visit us at: http://bit.ly/ThisOldHouseWebsite How to Heat a Garage Workshop | Ask This Old House    / thisoldhouse