CR10S5 OctoPi Setup скачать в хорошем качестве

CR10S5 OctoPi Setup

Setting up a Raspberry Pi 3B with a Raspberry Pi Camera with OctoPi to help monitor and control your 3D printer. In this video, I will be setting up OctoPi on my CR10S5 printer. To do the same with your printer, you will need: A raspberry Pi 3B A 16GB or bigger micro SD card A Raspberry Pi Camera. An active network connection, either WiFi or Ethernet. While the following was created for the Ender 3, it also works for the CR10S5. Ender 3 Side-Mounted Pi Case by OldSchoolDog on Thingiverse: https://www.thingiverse.com/thing:371... Raspberry Pi Camera Arm by altrome is licensed under the Creative Commons - Attribution - Share Alike license. https://www.thingiverse.com/thing:547506 http://creativecommons.org/licenses/b... You can find the image for OctoPi here: https://octoprint.org/download/ The best SD Card formatter I know of can be found here: https://www.sdcard.org/downloads/form... Below is the easiest SD card imager program I've found so far. https://www.balena.io/etcher Don't for get to subscribe and click on the notification bell to be notified of new video being released. Other videos on 3D printing: CR10S5 Unboxing:    • CR10S5 unboxing   CR10S5 BLTouch Upgrade Part 1:    • CR10S5 BLTouch Upgrade Part 1   CR10S5 BLTouch Upgrade Part 2:    • CR10S5 BLTouch Upgrade Part 2   CR10S5 Heated Bed Upgrade Part 1:    • CR10S5 Heated Bed Upgrade part 1   CR10S5 Mod to BLTouch:    • CR10S5 Mod to BLTouch mod   CR10S5 Heated Bed Upgrade Part 2:    • CR10S5 Heated Bed Upgrade part 2   CR10S5 Repairing the After Market BLTouch:    • CR10S5 Repairing the After Market BLTouch   Cocoon Create Touch adding rear Z braces:    • Cocoon Create Touch adding rear Z brace   Cocoon Create Touch Firmware Update:    • Cocoon Create Touch Firmware Update   Cocoon Create Touch BLTouch printing too high on right side:    • Cocoon Create Touch BLTouch printing too h...