Using OMPHobby Protocol in OpenTX - Updating Multi-Module Firmware скачать в хорошем качестве

Using OMPHobby Protocol in OpenTX - Updating Multi-Module Firmware

Using OMPHobby protocol in OpenTX is now possible thanks to the latest stable version of multi-module firmware. I'll show you how to easily update the firmware in your OpenTX radio / transmitter with an internal or external multi protocol module. Thanks to Multi-Module.org's website download tools, and the newer versions of firmware already installed in the latest OpenTX radios and multi modules, the firmware updating process of multi-protocol modules is now very simple. Nothing like it used to be with special drivers or even hardware needed. All you'll need is your OpenTX radio, a computer with an internet connection, and a few minutes of your time. Important Note: I'm using pitch curves on channel 3 which is totally optional and up to you. I do this specifically to cater the collective ranges to my liking. If you just use a single linear output on channel 3 with no pitch curves programmed in, the OMP flight controller will set a default -3 to +12 degrees of collective in the low head speed mode & about +/-12 degrees of collective in the mid and high speed modes. Again, this is ONLY when paired with the internal OMP receiver. This is done so the simple non computerized OMP radio that has no programable pitch curves can still limit the collective range to a typical/conventional "normal flight" range in the low head speed mode along with a full -12 to +12 range in both higher head speed modes. If you are okay with those "factory default" collective ranges, feel free to omit setting up any pitch curves and just use a linear output for channel 3. Useful Links: 1. Multl-Module's website: https://www.multi-module.org/ 2. Create logical switches to throttle off at low stick with OMP protocol video:    • How to Throttle OMP M2/M1 Helicopter Off a...   3. OMP Telemetry Activation:    • OMP Telemetry Is Available - How To Get It...   4. Basics of collective pitch RC helicopter setup in OpenTX:    • Basics of RC Helicopter Transmitter Setup ...   5. OpenTX RadioMaster TX16S TX used in this video: https://www.banggood.com/custlink/Gv3... 6. RadioMaster TX16S full review:    • RadioMaster TX16S Review & Thoughts   7. OMPHobby M1 Review:    • OMPHobby M1 Review - Amazingly Fun Micro 3...   8. OMPHobby M2 Explore Review:    • OMPHobby M2 Explore RC Helicopter Review   9. OMPHobby M2 V2 Review:    • OMP M2 V2 Review & Flight Including Compar...   10. OMPHobby M2 Explore Heli used in this video: https://www.banggood.com/custlink/KKD... Video Chapter Time Index: Intro 0:00 Identifying current version of multi-module firmware 0:59 Overview of Multi-Module.org's website 1:41 Downloading latest stable version of firmware 3:05 Installing Multi-Module firmware 5:15 Flashing new firmware to Multi-Module 7:49 Binding the OPMHobby receiver to the radio 9:58 Frequency fine tune procedure 11:26 OMP channel assignment re-ordering in mix menu 12:54 Confirming & testing M2 heli channel functions 20:20 Conclusion 27:52 DISCLAIMER: Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. There is no additional charge to you! Thank you for supporting RCHelicopterFun.com & my channel which helps me keep creating content. Please consider giving a thumbs up & subscribe if you enjoy my content - thank you.