2000 Jeep XJ (Cherokee) Double DIN radio install and "NO BUS" fix скачать в хорошем качестве

2000 Jeep XJ (Cherokee) Double DIN radio install and "NO BUS" fix

In this video we do a step by step install of a SONY XAV-AV5600 double DIN radio using a Metra 95-6554B bezel and Metra 70-1817 radio wiring harness. We also install a reverse camera and show you how to find the reverse light signal as well as route the wires to the front. While we are busy we remove the instrument cluster to clean the contacts as we had the cluster show us a NO BUS error. We also repair a damaged wiring harness at the rear between the trunk or boot and the body shell. Parts: https://amzn.to/4qUbW6k Metra 95-6554B Bezel https://amzn.to/4sEipUA Metra 70-1817 Radio wiring harness https://amzn.to/3Nm7Vcr NOTE Radio is not the same, please check fitment 00:00 - Introduction 00:13 - Metra 95-6554B bezel and bracket discussion and parts needed 01:37 - Backup camera installation plan 02:40 - Damaged wiring harness repair 03:57 - Finding the reverse light signal wire 04:42 - Backup camera wire installation and routing on the rear door 06:05 - Bezel and factory radio removal 07:46 - Testing the power wires and making the jumper harness 10:06 - Removing hardware from the old bezel and installing them onto the new Metra 95-6554B bezel 11:37 - Routing the backup camera wire to the front of the Jeep 12:41 - Investigating and repairing the "NO BUS" error 14:25 - Finishing the backup camera wire routing to the radio 16:42 - Modifying the Right side radio mounting bracket 17:56 - Cutting the Left side air duct and modifying the Left bracket 20:34 - Installing the USB and HDMI cables 21:13 - Installing the microphone for the radio 22:08 - Re-assembly of the dash and radio installation 24:34 - Bezel installation and final test