RJ45 Installation Guide: How To Assemble UTP 180-Degree Punch Down Keystone Jack скачать в хорошем качестве

RJ45 Installation Guide: How To Assemble UTP 180-Degree Punch Down Keystone Jack

Welcome to our quick tutorial on installing the UTP 180-Degree Punch Down Keystone Jack. In this video, you'll see how to easily wire and assemble an RJ45 keystone jack for structured cabling. To begin, use a cable stripper to remove about 3 cm of the outer jacket, then arrange the twisted pairs following the T568A or T568B wiring scheme. Terminate the wires into the 180-degree slim-type punch down jack using a compatible hand tool. Finally, snap on the cap to complete the assembly—quick, clean, and reliable. This UTP keystone jack is perfect for professional use, featuring a space-saving design and fast, secure termination. 👉 Don’t forget to like, share, and subscribe for more networking tutorials and CRXCONEC product demos! Video Time Codes: 00:00 Introduction 00:10 Required Tools 00:16 Step 1 Remove Jacket 00:24 Step 2 Organize the wire and cut off the cross bracket 00:33 Step 3 Sort Out Wires based on wiring diagram 00:42 Step 4 Install from remote pairs 01:09 Step 5 use termination tool to crimp and cut 01:19 Step 6 Put on the wire cap 01:24 Assembly Complete #rj45 #cabling #ethernet #cable #crxconec #keystonejack Product detail： Cat.6A 180 UTP Degrees Punch Down Keystone Jack: https://www.crxconec.com/en/product/C... ．Website：https://www.crxconec.com ．LinkedIn：  / crxconec   Catch us up on E-mail, Feel free to get more information ．[email protected]