Proper Water Flow & PSI for an ICS Powercutter скачать в хорошем качестве

Proper Water Flow & PSI for an ICS Powercutter

To keep your saw running smoothly, make sure it’s getting enough water to cool the chain and clear out abrasive slurry. You’ll need a water supply delivering at least 1.5 bar (20 psi) with a flow rate of 8 lpm (2 gpm). A quick tip: when the saw is connected to water, pull the chain to the side—if the water stream shoots up 30-45 cm (12-18 in), you’re saw has the appropriate pressure. It’s crucial to have the right amount of pressure because too little water flow will wear the chain out and too much pressure will reduce cutting efficiency. Disclaimer: This video is not intended as a replacement to the Operator Manual provided with every ICS power cutter. Read and understand the contents of the Operator Manual including all safety, warning, and proper use instructions before using this tool. Failure to follow the warnings and instructions may result in fire, serious injury or death. If an Operator Manual was not provided to you, please scan the QR code on the saw or visit our website and download a copy: https://icsdiamondtools.com/en/docume...