coil and wick build greater than 1ohm скачать в хорошем качестве

coil and wick build greater than 1ohm

Do you buddies question your machismo because you are vaping on an e-cig? Does your small cloud output leave your girlfriend unfulfilled? This is a variation of a micro coil built to run about 10-20 watts.so you can tell your buddies...neener neener neeener 1mm drill bit 28ga Kanthal wire (about 8 inches should be lots) 15 1/2 wraps install on deck and fire, then compress. Should be centered right over air flow hole and glow evenly from middle. 2 or 3mm thickness of cotton bacon. Roll, twist one end and feed through coil. It will be a bit snug but shouldn't bunch up. Clip end just past the deck plate, fold up, install RBA chamber. Fluff cotton to cover both holes. You will want the majority of the cotton right over he holes, there isn't much so you want as much as possible wicking. Prime coil well. Prime wick ends GENTLY.. wet them but don't disturb their position. Put the RBA top cap back on. Put the Atty back together (screw bottom into top) Set mod to lowest setting (5w on mine, and increase in stages. 5, 7, 10, 12. 15. 20. 12 should be your "sweet spot" allowing a very long pull, no burnt taste, huge vape cloud, great flavor! This build works great on a vplum (6-16w) e-cig battery