RSPro SUP rail protection installation HD скачать в хорошем качестве

RSPro SUP rail protection installation HD

TIPS for a perfect fit: 1. Don't install it on a cold environment. We recommend to install it at room temperature. Below 18ºC (65F) the material and glue tend to get rigid, so it would make the installation more difficult. 2. Unroll the rail protection bands and place on at each side of the board. 3. Mark with a pencil the center of the rail protection band. 4. Before removing the backing, place the center of the rail protection band at the center of the board rail and extend it to the nose, mark the board with a pencil where the start of the rail protection band should be. Now you have the perfect placing longitudinally. 5. Start peeling the front side of the rail protection band and start sticking it where you marked the board and on the edge of the board rail (this is the more external part of the board, and where all impacts will take place). Follow the board edge until the end. As you can see at the video it's easy to reposition while installing it, but once it's fixed, after some time, it can't be repositioned again. We recommend to wait for 6 hours before going to the water. If your board coating/painting is weak, or if you prefer to play around with the rail protection band until you find the perfect spot, spray some clean water over the rail of your board. It will allow you to move the rail protection band, and once placed, remove excess water with a squeegee. Rest of the water will evaporate by itself after some hours. If you need to remove it, we advice to apply some heat with a hairdryer or heatgun to soft the adhesive and to make it easier to remove. Check it out at www.rspro.org