Novsight HALO Pro Series LED Pod Lights ACC connects wires Guide Installation - 6-inch spotlight скачать в хорошем качестве

Novsight HALO Pro Series LED Pod Lights ACC connects wires Guide Installation - 6-inch spotlight

Novsight HALO Pro Series LED Pod Lights ACC connects wires (recommend) Guide Installation - 6-inch spotlight This Video Shows Installation Method 2 ACC: Put the white wire and ACC connect wires together to the Running Daylight controller position of car Please verify that all accessories are included before beginning installation Step 1: Determine the installation location for the HALO 6-inch spotlight Set up the standing bracket on your vehicle Install the screws and nuts on the side of the standing bracket to fix the direction of the spotlight Step 2: Connect Wiring Harness Three installation methods are available (Standard, ACC, and Switch Panel) This Video Shows Installation Method 2 ACC：Put the white wire and ACC connect wire together to the Running Daylight controller position of car First connect the main Wire (DT 4-Pin Wire) interface of the wiring harness The black one is the negative connection wire The red one is the positive connection wire The white one is the protective wire-day running light connection wire (White wire that also must be connected） The red wire is connected to the positive terminal of the vehicle The black wire goes to the negative terminal on the vehicle Daytime running light ACC connection wiring (Note: Purchase separately according to the vehicle model, ACC connection wiring not included in the package) Connect to white wire (That the protective wire - the day running light connection wire) Connect the white wire and ACC wire together and install it at the controller of the daytime running light (Depending on the vehicle model you own) Connect the spotlight switch, main light source and daytime running light button After alignment, tighten the two connecting wires by rotating them Step 3: Test whether the main light source and daytime running lights of the spotlight are functioning normally (Controlled by buttons) Short press the daytime running light mode button on the right to turn on the light, and then Long press the main light button on the left to reset the light source and restore to daytime running light Mode 1 (Constant light mode) Short press the daytime running light mode button on the right to turn on the daytime running light Short press the button again to switch the daytime running light mode There are 7 different modes for the daytime running lights (Yellow light first, then white light) Short press the button on the left side of the main light source to turn on the main light source At the last, long press the day running light button turn off the light #novsight #novsightled #automobile #offroad #offroad #ledlightbar #Novsight #NovsightHalo #4x4truck #4x4Life #OffRoad #OffRoadLights #LEDLighting #Overlanding #LightTheTrail #TruckMods #offroadcommunity #BuildNotBought #offroadnation #awningtent #awning #carsideawning #Novsight #NovsightHalo #4x4 #OffRoad #Overlanding #JeepLife #JeepMods #OffRoadCommunity #BuildNotBought #LEDLights #OffRoadLighting #offroadusa #offroad #offroadlighting #overlanding #carlights Welcome to follow Novsight's Facebook and Instagram! Facebook:   / novsight.led   Instagram:   / novsight